Electrolux Pure i9.2 showing “Water was vacuumed into the robot” has a specific manufacturer-backed troubleshooting path. Match the exact light, sound or behaviour before cleaning, resetting or ordering anything. Confirm “Water was vacuumed into the robot” exactly, including the full number, colour, flash order, spoken phrase or screen text. If any element differs, use the guide for that other indication instead. Electrolux — Pure i9 water ingress documents this condition for Electrolux Pure i9.2. It identifies the branch to test, but it does not by itself prove that a battery, motor, board, sensor, dock or replaceable part has failed. Stop immediately, keep the robot off its charging base and do not run a drying test. Electrolux sends this condition to an authorised centre for motor replacement and notes that water damage is not covered by warranty. Power the robot off and remove it from the dock before turning it over or touching a moving part. Keep charging contacts dry and never open the battery pack or electronics housing. Run only one normal start, charge or cleaning cycle after the documented check. If “Water was vacuumed into the robot” returns unchanged, record the code, model and serial number and contact authorised Electrolux support instead of repeating resets or guessing a part.
Models covered
Safety first
- Power the robot off and remove it from the dock before turning it over or touching a moving part. Keep charging contacts dry and never open the battery pack or electronics housing.
What the symptom may indicate
Checks in the right order
- Identify the exact indication
Confirm “Water was vacuumed into the robot” exactly, including the full number, colour, flash order, spoken phrase or screen text. If any element differs, use the guide for that other indication instead.
- Safe check to perform
Stop immediately, keep the robot off its charging base and do not run a drying test. Electrolux sends this condition to an authorised centre for motor replacement and notes that water damage is not covered by warranty.
- What to do after the test
Run only one normal start, charge or cleaning cycle after the documented check. If “Water was vacuumed into the robot” returns unchanged, record the code, model and serial number and contact authorised Electrolux support instead of repeating resets or guessing a part.
Stop and get qualified help when
- Stop for liquid on the robot or dock, a swollen battery, burning smell, hot or discoloured contacts, damaged wiring or the same alert after the single documented check. Run only one normal start, charge or cleaning cycle after the documented check. If “Water was vacuumed into the robot” returns unchanged, record the code, model and serial number and contact authorised Electrolux support instead of repeating resets or guessing a part.
Next step
Repair, replace a part, or arrange a diagnosis?
Use the checks and stop conditions above to choose a cautious next step. A symptom alone never proves that the appliance has failed.
Resolve it without buying anything
Complete the 3 user-accessible checks in order. If normal operation returns and no warning sign remains, no replacement is indicated.
Replace only the confirmed part
If the checks isolate a worn or blocked component, match its complete reference to the exact appliance model before ordering.
This guide does not identify a replacement part. Do not order a generic component from the symptom alone.
Arrange a diagnosis before replacing the appliance
Stop at any warning sign listed above. A qualified diagnosis should confirm that repair is unsafe, unavailable or uneconomical before an appliance replacement is considered.
Sources used
- Electrolux — Electrolux, Pure i9 water ingress: “Il sera nécessaire de remplacer le moteur dans un centre de service après-vente Electrolux agréé.” This exact manufacturer wording anchors the check for Electrolux Pure i9.2.
Last checked: 30 August 2026